S3 Clock tools Homework - Quiz
- 1. Which tool was used to Mark lines at 90 degrees (Right angle) to the edge of the wood?
A) Steel Rule
B) Marking Gauge
C) Tri-Square
- 2. What kind of saw is tool “D” ?
A) Hack Saw
B) Cross Cut Saw
C) Mitre Saw
D) Tenon Saw
- 3. Which tool did you use to measure the sizes of the joints?
A) Tri-Square
B) Marking Gauge
C) Steel Rule
D) Protractor
- 4. Name the tool we used “E” to support the wood while sawing.
A) Vice Guard
B) Holding Bracket
C) Block Board
D) Bench Hook
- 5. Which tool was best suited for marking lines parallel to the edge of the wood?
A) Marking Gauge
B) Scriber
C) Tri-Square
D) Steel Rule
- 6. Tool “F” was used to remove scrap wood from our joints. What is it called?
A) Hand Scraper
B) Rough Cut File
C) Mortise Gauge
D) Bevel Edged chisel
- 7. We used this tool to chamfer some of the clock parts. What is it called?
A) Router
B) Jack Plane
C) Finisher
D) Smoother
- 8. We used this Glue to assemble the clock. What type of glue is it?
A) Contact Adhesive
B) P.V.A.
C) Super Glue
D) Epoxy Resin
- 9. We finished a few parts of our clock on the Band facer.. Give a safety rule that we used here.
A) Keep away from water.
B) Goggles were worn.
C) Hard hat required.
D) Wear safety gloves
- 10. When we were cutting our joints as shown in the photo, what safety rule were we folhighing?
A) Must wear safety goggles.
B) Use a heavy mallet.
C) Strike the chisel heavily.
D) Both hands behind the cutting edge of the chisel.
|